Time to verbal and nonverbal responses and time to motor power 3/5 did not differ between the two groups (P > 0.05). The number of doses received by each patient and the percentage of patients needing more than one dose were significantly greater in the propofol group (P < 0.005). Only one patient developed confusion, combativeness, and agitation. Despite the need for multiple doses, our patients had no residual drowsiness within 10 to 15 minutes of the propofol injection. This allowed us to perform the test on both sides on the same day separated

only by 45 minutes. Propofol is an effective alternative to amobarbital in the Wada test, and may be used Successfully in multiple repeated injections within the same test without significant residual sedation or significant adverse effects. find more (C) 2009 Elsevier Inc. All rights reserved.”
“Although blood pressure cuffs are commonly used and shared in medical facilities, their routine disinfection is performed infrequently.

We investigated the contamination GSI-IX concentration of blood pressure cuffs by methicillin-resistant Staphylococcus aureus (MRSA).

The MRSA level on the inner

side (the surface in contact with patients’ skin) of blood pressure cuffs used in the wards and outpatient clinics of a university hospital (733 beds) was determined using the gauze and swab wiping methods.

Using the

gauze wiping method (n = 35), the MRSA contamination rate was 31.4 %, and the MRSA contamination level was 1,702.6 +/- A 9,996.1 (0-58, 320) colony-forming units (cfu)/cuff. No MRSA was detected on blood pressure cuffs after washing (n = 30) or wiping with 80 vol% ethanol (n = 18).

Blood pressure cuffs are frequently contaminated by MRSA.”
“This article describes a dry and durable electro-active paper (EAPap) actuator based on natural biodegradable polymer: cellulose and chitosan. To fabricate this actuator, cellulose and chitosan were dissolved in trifluoroacetic acid. The solution was cast to form a film followed by depositing thin gold electrode on both sides of the film. The actuator was actuated under AC voltage at an ambient condition by changing the actuation voltage, frequency, and time. The actuator revealed PP2 a large bending displacement under low voltage, electrical power consumption at low humidity condition. This cellulose-chitosan blended EAPap actuator is suitable for dry and durable actuator. Details about the fabrication, durability, electrical power consumption, and characteristics as well as morphology of the actuator are explained. (C) 2009 Wiley Periodicals, Inc. J Appl Polym Sci 115: 2044-2049, 2010″
“Study Design. Retrospective cohort study using a nationally representative inpatient database.

Objective.