Photocatalytic activity of calcined fibers The photocatalysis of the samples was studied by the degradation rate of MB in UV light. P25 was used as a contrast. GSK2245840 The samples were stirred constantly for 30 min before UV irradiation to achieve

selleck absorption equilibrium. The solutions were stirred continually under UV light irradiation, after which 5 mL of degradable MB solution was obtained every 10 min from the solutions. The samples were analyzed by UV spectrophotometry. From the results shown in Figure 5, the concentration of solution declined over 50% in the first 10 min for all fibers. After 40 min, the lowest concentration was almost below 5%. The fibers treated at 500°C and 550°C in N2 had the same degradation rates as the fibers treated at 650°C in N2 and NH3. This result agrees with the XRD analysis. The fibers treated Pevonedistat molecular weight at 600°C in NH3 showed the best catalytic activity. Figure 5 Photocatalytic activity of heat-treated fibers at different temperatures. Figure 6 shows the UV–vis absorption spectra of the samples that are heat-treated under different conditions as well as that of P25. The samples were heat-treated at different temperatures and then heated in N2 or in NH3 for 4 h. The curves showed strong absorption at 200 to 350 nm, which is a feature of TiO2. All of the fibers

have different absorption strengths above 400 nm compared with P25. Above 400 nm, the absorption of P25 was nearly zero. Therefore, the synthesized fibers are responsive to visible light. Changes in the Ti-O crystalline lattice broaden the energy band by the nitriding process. At the same temperature but different protective atmospheres, the absorption strength of samples in N2 is stronger

than that in NH3. The absorption strength of samples gradually decreased with increasing temperature in the same preservation atmosphere, which is caused by the transformation of the TiO2 crystalline phase with increasing temperature. Figure 6 UV–vis absorption spectra of samples at different temperatures. UV–vis absorption spectra of samples at different temperatures in N2 (top) and NH3 (bottom) and P25 TiO2 powders. Figure 7 selleck chemicals shows the absorption spectra of the MB degraded by fibers that were heat-treated at 550°C at different atmospheres. The absorption curve has a maximum absorbance peak at 660 nm. During the experiment, the absorbance peak shifted from 660 to 645 nm after 40 min, as shown in Figure 7. According to previous researchers, reductions in the absorbance observed are probably due to the degradation of MB chromophores, and shifting of the absorption peak may be due to demethylation occurring at the catalyst surface [9, 19]. Figure 7 UV–vis absorption spectra of methylene blue which were degraded by fibers. UV–vis absorption spectra of methylene blue which were degraded by fibers at 550°C preserved heat in N2 (top) and NH3 (bottom).