In the VLS mode [17, 18], the substrate

In the VLS mode [17, 18], the substrate temperature usually is higher, and the catalyst grains are unstable on the substrates. The CdS nucleation would firstly occur at the bottom of the catalyst particles; then, the CdS nuclei push up the catalyst, and the catalyst-leading nanoneedles are eventually formed, as shown in Figure 1b. Because of the instability of catalyst pellets, the nanoneedles were usually crooked. Figure 1 KPT-8602 in vivo growth models for CdS nanoneedles of (a) VS and (b) VLS modes. The effects of the substrate temperature on the growth of the CdS nanoneedles

were examined. When the substrate temperature was changed by the step of 50°C and kept other conditions (a laser pulse energy GDC-0068 order of 50 mJ, a repetition rate of 10 Hz, a deposition duration of 30 min, Ni layers deposited at 50 mJ, 5 Hz, and 15 min) unchanged, the density of nanoneedles Selleck CB-839 increased higher from zero at a substrate temperature of 200°C to about 4 × 108 cm-2 at 400°C and even 2 × 109 cm-2 at 450°C; after that, it declined rapidly until the morphology became flat at a substrate temperature of 500°C. The morphology of single nanoneedles prepared at a substrate temperature of 400°C is straight with the average

middle diameter and length of 50 and 800 nm, respectively, as shown in Figure 2a. The growth mechanism is typically VS mode, in which the plasma produced by laser ablation directly deposits on the crystal nucleus and the intact nanoneedles are formed. When the substrate temperature was raised to 450°C, the nanoneedles become bent and have catalyst balls on the tops, which indicates the catalyst-leading over VLS growth mode of the CdS nanoneedles (see Figure 2b). Figure 2 FESEM images of CdS films grown on Ni-covered Si(100). At the substrate temperatures of (a) 400°C and (b) 450°C. The samples were prepared under the same laser pulse energy of 50 mJ. The deposition time,

pulse energy, and frequency of catalyst-Ni were 15 min, 50 mJ, and 5Hz, respectively. In the nucleation of the CdS nanoneedles, it has been thought that the laser-ablated precursors firstly deposit on the molten catalyst spheres or migrate to them from the substrate, then dissolve into the molten catalyst pellets and separated out around the pellets after saturation. So, the formation of the molten catalyst spheres is the key to the nucleation of the CdS nanoneedles. The morphologies of the Ni catalyst thin films annealed at different substrate temperatures for 5 min were shown in Figure 3. It is apparent in Figure 3a,b,c that the Ni thin films gradually melted and the Ni spheres began to form with the increase of the temperature from 200°C to 400°C.

Comments are closed.